Table of Contents
Advertisement
4. Commands of Input / Output signal
(1) TRIGGER ： Setting of the external trigger
・SELECTOR ： Select the trigger action
Command name
Address
Values (Factory setting 1) ： 1 "FrameStart" Select this when using normal trigger mode.
・MODE (related to SELECTOR) ： Select the mode selected at SELECTOR
Command name
Address
Values (Factory setting 0) ： 0 "Oｆｆ"
・SOURCE (related to SELECTOR) ： Select the trigger source selected at SELECTOR
Command name
Address
Values (Factory setting 0) ： 0 "Line1"
・POLARITY (related to SELECTOR) ： Select polarity of trigger signal selected at SELECTOR
Command name
Address
Values (Factory setting 1) ： 0 "FallingEdge" Falling of input signal is made into trigger signal.
・SOFTWARE (related to SELECTOR) ： Generate the software trigger selected at SELECTOR
Command name
Address
Values (write only)
・DELAY TIME1 (related to SELECTOR) ： Set the duration of trigger delay selected at SELECTOR
Command name
Address
Values
・DELAY TIME2 (related to SELECTOR) ： Set the duration of trigger delay selected at SELECTOR
Command name
Address
Values (Factory setting 0) ： 0 to 4095
Note
: Since DELAY TIME1 and DELAY TIME2 are linked together,
if one is changed then the other is changed to corresponding value.
(2) DIGITAL I/O ： Setting of input / output line
*Refer to page 26 "Trigger mode" about details of trigger mode
： TriggerSelector (Enumeration / Standard）
： A0030020 h
4 "FrameTransferStart"
5 "VDReset"
Select this when using VD reset mode.
： TriggerMode (Enumeration / Standard）
： A0030024 h
Set trigger mode selected at SELECTOR to OFF.
1 "On"
Set trigger mode selected at SELECTOR to ON.
： TriggerSource (Enumeration / Standard）
： A003002C h
Input trigger signal from 7 pin of DCIN/SYNC connector (TRIG A).
2 "Line3"
Input trigger signal from 9 pin of DCIN/SYNC connector (TRIG B).
7 "Software"
Use software trigger.
： TriggerActivation (Enumeration / Standard）
： A0030030 h
1 "RisingEdge"
Rising of input signal is made into trigger signal.
： TriggerSoftware (Command / Standard）
： A0030028 h
： 1
Whenever 1 is written, the software trigger is generated.
： TriggerDelay (Float / Standard）
： A0030034 h
： (Refer to table)
A range and a step of trigger delay time was shown below.
： TriggerDelayRaw (Integer / Standard）
： A0030038 h
A range and a step of trigger delay time was shown below.
Selected trigger action
FrameStart
FrameTransferStart
Select this when using reset control mode.
*using when SOURCE is Software
Range 0 ~ 4095
0.44µs ~ 6.55ms
56.36µs ~ 6.61ms
step
approx.1.60µs
18
Advertisement
Table of Contents
