Device Setup - T+A DD 820 M User Manual

The system is controlled entirely using the F6 remote
control handset. Hold the AMP button pressed in for
about 3 seconds to open the 'Configuration Menu'. Use
the   /   buttons to select a menu point, and change
   
the value with the     /    buttons. 
Switching the on-screen main menu on
and off:
If you just wish to make a temporary change to the
balance or tone, it is not absolutely necessary to call up
the 'Main Menu' on
superimpose it on what you are watching; in most cases
the display on the decoder's screen is quite adequate. At
this menu point you can switch the TV on-screen main
menu display on and off.
off The 'Main Menu' appears line by line on the
decoder's screen, but not on the TV screen.
on The 'Main Menu' appears on the TV screen
and also line by line on the decoder's
screen.
On-screen language:
The on-screen menus can be displayed on the screen in
a variety of languages. The on-screen menus then
appear in the language you select.
Setup-Assistant:
The 'Setup assistant' menu point represents an
alternative to the manual 'Loudspeaker Menu'. Calling
up the Assistant invokes an automated routine for
correctly setting up the individual loudspeaker channels
of your surround system.
Loudspeaker:
The 'Speaker Setup' provides the means to balance the
output signals to the loudspeakers in your surround
system. At the same time you can adjust the output of
the speakers accurately to suit the acoustic and spatial
characteristics of your listening room.

Device Setup

the television screen
The menu can be closed again at any time by pressing
the   or   button.
   
Picture norm:
In this menu you set the picture norm for the TV output.
and
Source:
The 'Inputs Menu' is used to assign the digital input for
the source STB.
45