Setting Top-Of-Form for a cut form
or envelope
Top-Of-Form can range from minus 1 to plus 22 inches
from the top of cut sheet paper. To set and save
Top-Of-Form:
1 Clear the paper path.
The Paper Out light blinks if no paper is loaded.
If the Paper Out light is Off, tear off excess
forms and press Load/Unload.
If a single form is loaded, press FormFeed to
clear paper path.
2 Move the paper select lever up to the cut
forms
position.
3 Load a cut sheet of paper or envelope through
the manual feed door.
For help loading paper, see "Loading a cut form
or envelope manually" on pag e73.
•
If Auto Cut Sheet is set to On, the printer
moves the paper or envelope to the current
Top-Of-Form
•
If Auto Cut Sheet is set to Off, press
FormFeed when the Paper Out light goes
Off.
4 Open the operator panel cover to access layer 2.
5 Press any paper movement button (LineFeed,
Micro , Micro ) to align with the horizontal
lines (located on the platen) with the Top-Of-
Form you want.
See the illustration, on " on pag e83.
Note: If you press and hold a paper movement
button, the paper advances in micro
movements and then goes into
continuous feed.
85