Lexmark 2480 User Manual page 138

Printer problems
Problem
Printer does not feed
paper.
Cannot adjust right
tractor past rubber
tractor stop in pull
tractor position.
Probable cause
Paper is jamming.
The forms thickness lever
is set incorrectly for the
type of paper you are
using.
The Continuous form
paper is parked.
The Auto Cut Sheet Load
option is not set.
The right paper guide is
not set correctly for your
paper width.
The paper select lever is
in the wrong position.
Rubber tractor stop has
been pushed out of
seated position.
134
Action
• Remove all forms and
pieces of paper. Look for
loose pinfeed hole strips
that can sometimes tear
from continuous forms and
remain in the printer.
• The right tractor position
may be incorrectly
adjusted.
• Before you load new
forms, fan the forms to
loosen the sheets.
See "Setting the forms
thickness lever" on page 44
for more information.
Press Load/Unload.
See "Auto Cut Sheet Load" on
page 97 for more
information.
Adjust the right paper guide.
• If you are trying to print a
cut sheet, make sure the
paper select lever is in the
cut sheet position.
• If you are trying to print
continuous forms, make
sure the paper select lever
is in the continuous sheet
position.
Firmly slide tractor and rubber
tractor stop.