pyrexx PX-1C Operating Manual page 65

(2) Release testing / stop button
(3) Perform similar actions for other
radio groups
5 Successful connection test of the sin-
gle device and the shared radio group
6.8 Restore factory defaults
In the following situations, you must re-
store the factory settings:
Connection attempt was unsuc-
•
cessful and must be repeated
To detach a device from a radio group
•
EN EN
s h o r t a c o u s t i c s i g n a l ,
single device
s h o r t a c o u s t i c s i g n a l ,
single device
s h o r t a c o u s t i c s i g n a l ,
single device
short acoustic signal,
all devices of the shared
radio group
Operating Manual: PX-1C - Smoke Alarm Device with Radio Link
Proceed as follows:
(1) Pull out activation button
(2) Press and hold the testing / stop but-
ton for about 2 to 3 seconds
(3) Press and hold the radio button with
splint pin until:
(4) Release radio button
5 The device is in the factory state
Cancel a device from a radio group
You must cancel a device from a radio
group in the following cases:
Remove device from an
•
existing radio group and
connect it to another group
Remove the defective device
•
from the radio group
65