Epson PowerLite 1705c User Manual page 90

note
Only the Epson Ethernet
unit is guaranteed to work.
Other brands may not be
compatible.
If you see a message asking
you to insert a LAN or
memory card, check to make
sure your Ethernet unit is
properly inserted.
note
If you're a network
administrator, you can use
the SNMP option to enter a
trap IP address. This lets you
receive trap alerts for the
projectors you're monitoring.
Presenting Through a Wireless Network
90
Downloaded From projector-manual.com Epson Manuals
2. Connect the projector to your network using a commercially
available 100BaseTX or 10BaseT network cable. Connect the
cable to the port on the projector.
LAN
3. Point the remote control at the projector and press the P
button.
4. Press the
EasyMP
as the source.
5. Press the button on the remote control, select the
Menu
menu, then press
Network
6. Choose
To Network Configuration
7. Choose
Wired LAN
You see the following screen:
8. Do one of the following:
If your network assigns addresses automatically, turn on the
■
setting.
DHCP
If your network does not assign addresses automatically, turn
■
off and enter the projector's
DHCP
,
Mask Gateway Address
button on the remote control to select EasyMP
.
Enter
and press
and press .
Enter
IP Address
, and
DNS Servers
Power
.
Enter
,
Subnet
, as needed.