Turn On Your Equipment C onnect the power cord to the back of the projector and plug the other end into an electrical outlet. Open the A/V Mute slide. Make sure the slide is opened completely. R emove the battery cover on the remote control. Locate the two AAA batteries that came with the projector and insert them. Then replace the battery cover. T o turn the projector on, press the Power button on the projector or the remote control. The projector beeps once, and the projector’s Power light flashes green and then stays on. Power button CAUTION: Before unplugging the projector... Shut the projector down properly: 1. Press the Power button twice. 2. When the orange light stops flashing and the projector beeps, you can unplug the projector.
Turn the focus ring to sharpen the image. Turn the zoom ring to reduce or enlarge the image. Focus I f your image looks like to one side of the screen at an angle. Place it directly in front of the screen, facing the screen squarely. I f your image looks like the projector to correct it. Choose a Presentation Method How do you want to get images to the projector? • T o connect to a notebook, see “If connecting to a notebook” below. • T o project over a wireless network, see “If projecting wirelessly” on the back of this sheet. Y ou must have installed the projector’s EasyMP™ software and configured your projector and computer before you can project wirelessly. See your User’s Guide for instructions. • T o give a presentation stored on a flash drive, digital camera, or other USB storage device, see Chapter 5 in your User’s Guide. • T o connect to your notebook using the included USB cable, see your User’s Guide. If connecting to a notebook... M ake sure you’ve turned on the projector and adjusted the image as described in sections 1 and 2.
I f you see a blank screen or you don’t see the image you are trying to project from your computer, make sure the Power light on the projector is green and not flashing, and the A/V Mute slide is open. If the screen is still blank, restart your notebook, or press the Source Search button on the projector again. Windows ® : Hold down the Fn button on the keyboard and press the function key that lets you display on an external monitor. It may have an icon such as I f your projector and notebook don’t display the same image, do the following: Windows: Try using the CRT/LCD or above. If this doesn’t work, double-click Display in the Windows Control Panel. Make sure both the LCD screen and monitor port are enabled. (Allow a few seconds for the projector to sync up.) See your Windows online help for details. Macintosh OS X: ® Preferences, then click Displays. Select the VGA Display or Color LCD dialog box, click the Arrangement (or Arrange) tab, and make sure Mirror Displays is checked. I f you see an image but it’s not displayed correctly, press the Auto button on the remote control to automatically readjust it. If projecting wirelessly... Follow the steps in this section to project over an 802.11g, 802.11b, or 802.11a wireless network from a computer running Windows 2000, XP, or Macintosh OS X 10.3 or above. NOTE: You must have already installed the projector’s EasyMP (EMP NS Connection) software and configured your projector and computer.
You can use the registration card or CD included with your projector, or register online at www.epson.com/webreg. Epson is a registered trademark and EasyMP and Exceed Your Vision are trademarks of Seiko Epson Corporation. PowerLite and PrivateLine are registered trademarks of Epson America, Inc.