Out Of Scanning Range; Cannot Transmit/Receive Data; Using Rs-232 Cable; Using Usb Cable - CipherLab 8600 Reference Manual

OUT OF SCANNING RANGE

Try adjusting the scanning distance from the scanner to the barcode.

CANNOT TRANSMIT/RECEIVE DATA

USING RS-232 CABLE

Check if the RS-232 connection is correct and secured.
Make sure the serial port parameters on the host are configured to match the serial
parameters on the mobile computer. Try to establish connection again.
If the problem persists, run the Echo Test to check if the RS-232 interface between
the mobile computer and the host is working. (See

USING USB CABLE

Check if the USB connection is correct and secured.
Check if the USB driver has been installed. (See
If the problem persists, run the Echo Test to check if the USB interface between the
mobile computer and the host is working. (See
Note: For applications that require COM port to be occupied all the time, it is suggested
to use Fast VPort cable instead.

VIA BLUETOOTH

Make sure the distance between the mobile computer and a target device is within
proper range. Try to establish connection again.
Check if the relevant settings are correct. (See
If the problem persists, run the Echo Test to check if the connection is working
properly. (See 3.9.4 Echo

VIA WI-FI

Make sure the mobile computer is connected to an access point properly, under the
same SSID. Try to establish connection again.
Check if the relevant settings are correct. (See
If the problem persists, run the Echo Test to check if the connection is working
properly. (See 3.10.7 Echo
Tests.)
Tests.)
Appendix II
3.3.6 Echo Test.)
1.7 Charging & Communications.)
3.3.6 Echo Test.)
3.9 Bluetooth Menu.)
3.10 Wi-Fi Menu.)
Troubleshooting
101