CanyCom CM141 Operator's Manual page 72

Area Malfunction
Cutting blade does not
rotate
Cutting blade does not
stop
Cutting rotary drive
belt slips.
Abnormal vibration
occurs when cutting
blade is rotated.
Cutting
System
Cut grass is not
discharged properly.
Some grass is left
uncut.
Troubleshooting
Possible Cause
Cutting rotary drive
belt is severed.
Inappropary adjusted
Brake
Brake lining is worn.
Belt is loose.
Belt is worn.
Cut grass or vines
accumulate in the
cutting blade shield.
Cutting blade is
damaged or lost.
Foreign object is caught
by cutting blade.
Other (other than the
above).
Grass is wet.
Grass is too long.
Cutting height is too
low.
Engine speed is too low. →Raise engine speed.
Driving speed is too
high.
Grass is too long.
Engine speed is too low. →Raise engine speed.
Driving speed is too
high.
Cutting blade is
damaged or worn.
Cut grass or vines
accumulate in the
cutting blade shield.
-63-
Corrective Measure
→Replace.
→Replace.
→Adjust belt tension.
→Replace.
→Clean.
→Replace cutting
blades.
→Remove or clean
foreign object.
→Please contact
your CANYCOM
representative.
→Cut when grass is dry.
→Cut in several steps
at different heights.
→Raise cutting height.
→Drive slow.
→Cut in several steps
at different heights.
→Drive slow.
→Replace.
→Clean.
6
Ref.
Page 52
Page 52
Page 58
Page 49
Page 58