Troubleshooting; Maintenance - Healthstream FAN BIKE Owner's Manual

18
TROUBLE SHOOTING
Problem
Monitor does not display
No speed or distance
displays on the monitor
No tension
Grinding
Squealing

MAINTENANCE:

The safety and integrity designed into the Fan bike can only be maintained when the Fan bike is
regularly examined for damage and wear. Special attention should be given to the following:
1. Pedal slowly to verify that the Air Resistance System provides tension. The Air Resistance
System should provide many years of use.
2. Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember
that the left pedal has left hand threads and is tightened by turning counterclockwise.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten all loose nuts and bolts.
4. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
5. Worn or damaged components shall be replaced immediately or the Fan bike removed from
service until a repair is made.
6. Keep your Fan bike clean by wiping it off with an absorbent cloth after use.
Cause
Batteries not installed
Connected wire doesn't
connect with extension wire
of computer or sensor wire
Connected wire or sensor
wire damaged
Computer not
properly
Belt drops off the belt pulley
and groove of wheel
Idler pulley defective
Fan wheel defective
Poly V-belt slipping
Crank bearing defective
Idle wheel bearing defective
Fan wheel bearing defective
Correction
Insert batteries
Securely
wire into extension wire of
computer and sensor wire
Replace connected wire or
sensor wire
working
Replace computer
Put the belt back to the belt
pulley and groove of wheel
Replace idler pulley
Replace fan wheel
Adjust poly v-belt
Replace crank bearing
Replace idle wheel bearing
Replace fan wheel bearing
plug connected