Table of Contents
Advertisement
E L A N
Figure 3-11: Loop Audio Connections
© ELAN 2010 | All rights reserved.
Multi-Chassis Connections
Additional connections are required when using multiple M86As in a system. These
connections allow Source Audio IR, VIANet information, and Control to be shared between
the chassis. Up to four M86As may be used in one system.
Loop Audio Outputs
In a multi-chassis M86A system, it is necessary to use RCA cables to allow Source Audio
to be shared between the chassis. Connect RCA cables from the Audio Loop Outputs of
chassis # 1 to the Source Audio Inputs of chassis # 2 and continue this process until
source audio has been connected to all M86A chassis in the system.
Be sure that each source connects to the same Source Audio Input on ALL chassis.
M86A
INSTALLATION MANUAL
Page 25
Hide quick links:
Advertisement
Table of Contents
