Speaker Outputs - Elan M86A Installation Manual

E L A N
Figure 3-9: Speaker Connections
Figure 3-10: Quick Lock Connector
© ELAN 2010 | All rights reserved.

Speaker Outputs

The Quick Lock connectors on the M86A accept 18 to 16 AWG speaker wires. These wires
can be directly connected to speakers located throughout the home, or, for a professional
appearance, can be connected to speaker wall plates using bare leads or banana plugs.
Note: Because the Speaker Outputs are always VARIABLE, it is NOT RECOMMENDED to
use Volume Controls with the M86A's internal amplifier. Unanticipated volume
functionality may result. Sub-zones requiring the use of Volume Controls should utilize
an external amplifier connected to the M86A's ZONE PREAMP OUTPUTS. The ZONE
PREAMP OUTPUTS should be set for FIXED OUTPUT using the front panel DIP switch.
To Connect Speaker leads:
1. Open each Quick Lock connector.
2. Strip approximately 1/4" of the insulation from each speaker lead.
3 Twist the speaker wires to remove any loose strands.
4. Insert the leads into the connectors.
5. Close the connectors. Tug slightly on the speaker leads to ensure connectivity.
M86A
Important Notes:
Use 18-16 AWG Stranded Copper Speaker Wire
Do Not Configure Impedance Below 8 Ohms
Do Not Bridge the Internal Amplifier
Volume Controls are NOT Recommended
Do not allow wire strands to short
Connect speakers with power off
INSTALLATION MANUAL
Page 24