Stereo Zones - Elan M86A Installation Manual

E L A N
Figure 2-1: Typical stereo zone example.
© ELAN 2010 | All rights reserved.

Stereo Zones

To create an independent stereo zone, simply connect the M86A's Speaker Outputs to a
pair of speakers. Make sure to take into account the amplifier's 8 Ohm minimum
impedance when choosing and configuring speakers. Volume is controlled at preamp
level. Any speakers connected to these channels ramp volume up/down together. Use a
TS2 touchpad, TS7 touchscreen or hand-held remote to control functions (including
volume) in zones with this configuration.
M86A
INSTALLATION MANUAL
Page 14