Related Manuals for Elan Z-025
Summary of Contents for Elan Z-025
- Page 1 SPEAKER RELAY/ AUDIO DETECT SWITCHING MODULE INSTALLATION MANUAL P/N: 40615-121-03...
-
Page 2: Table Of Contents
ELAN’s control, or to improper operation, maintenance or storage, or to other than normal use of service. With respect to equipment sold by, but not manufactured by ELAN, the warranty obligations of ELAN shall in all respects conform and be limited to the warranty actually extended to ELAN by its supplier. The fore- going warranties do not cover reimbursement for labor, transportation, removal, installation, or other expenses which may be incurred in connection with repair or replacement. -
Page 3: Introduction
(i.e. TV) and automatically route the signal from the TV to the speakers when the TV is turned on. Turning OFF the TV (or selecting anoth- er source) will automatically re-route the speakers back to the ELAN system. The Z•025 will also automatically switch back to the ELAN system whenever a Page or Door Chime is detected, then revert back to the local source when the Page or Door Chime has ended. -
Page 4: Settings And Adjustments
Z•025 will wait before switching back to System Audio once TV Audio has been turned off. HOLD time can be adjusted between 3 to 60 seconds. © ELAN Home Systems • 2003 • All rights reserved. 2/03 Page 4... - Page 5 DO NOT MACHINE TIGHTEN. DO NOT LEAVE OUT THE SHORT SPACERS. OVERTIGHTENING MAY CAUSE DO NOT COMPRESS NYLON SPACERS. DAMAGE TO THE Z•100 PC BOARD OVERTIGHTENING MAY CAUSE © ELAN Home Systems • 2003 • All rights reserved. 2/03 Page 5...
-
Page 6: Connections
Use of the ELAN Z•027 12 VDC Regulated Power Supply is required when the number of keypads and Z•025s exceeds the maxi- mums specifed in the table on this page. © ELAN Home Systems • 2003 • All rights reserved. 2/03 Page 6... - Page 7 This diagram shows all the connections between the three power supply. ELAN Z027 12VDC Regulated C45P Power Supply or System6 (see Sys6 Manual for C45P details) C45P © ELAN Home Systems • 2003 • All rights reserved. 2/03 Page 7...
-
Page 8: Conntecting Z•025S To The Series Hd™ Mcu
Z•027 12 VDC Regulated Power Supply (See Page 9). # of Keypads MAX # of # of Keypads MAX # of 2010 per Zone Z025s per MCU Z025s © ELAN Home Systems • 2003 • All rights reserved. 2/03 Page 8... - Page 9 5.11). Never connect the 12VDC DO NOT OVERTIGHTEN from the HDC2010 Zone MOUNTING Card to the keypads when SCREWS––HAND TIGHT- using an external power EN ONLY. supply. © ELAN Home Systems • 2003 • All rights reserved. 2/03 Page 9...
-
Page 10: Connecting Z•025S To The Z•080 Stand-Alone Keypad Interface
The Z•080 Stand-alone Keypad Interface can power up to six Z•Pads with Z•025 Switching Modules. C45P WHITE/GREEN BLUE WHITE/BROWN WHITE/BLUE BROWN ORANGE WHITE/BLUE WHITE/ORANGE WHITE/GREEN GREEN WHITE/BROWN WHITE/GREEN BROWN BROWN WHITE/BROWN WHITE/BLUE ORANGE © ELAN Home Systems • 2003 • All rights reserved. 2/03 Page 10... -
Page 11: Adding A Dedicated Tv Amplifier
TV’s line-level output jacks and the Z•025’s speaker-level Out), it will be necessary to add an amplifier between the inputs. Just about any low-power amp will do for this Series HD Automation Card © ELAN Home Systems • 2003 • All rights reserved. 2/03 Page 11... -
Page 12: Connecting The Z•600 Comm Controler's Page & Doorbell Override Signal
Z•025’s/volume controls with override that can be is being provided by the Z•027 12 VDC Regulated Power connected when using a Z•027. ELAN Z027 Regulated Power Supply C45P © ELAN Home Systems • 2003 • All rights reserved. 2/03 Page 12... -
Page 13: Applications
Z•630 PreAmp Controller or Series HD™ MCU, or but dependent upon the receiver’s volume setting. Optional Automation Card TV IR Emitter ZPAD MCU, or System 6. © ELAN Home Systems • 2003 • All rights reserved. 2/03 Page 13... -
Page 14: Zone/Sub-Zone (Scenario 2)
System source select is not and the Sub-Zone can switch between System Audio and independent. Optional Automation Card TV IR Emitter or System 6 Optional Automation Card TV IR Emitter © ELAN Home Systems • 2003 • All rights reserved. 2/03 Page 14... -
Page 15: Zone/Sub-Zone (Scenario 3)
Z•600 to from the Z•600 to Controls with Controls with with Override with Override this many Z•025s this many Z•025s Override Override 2 or less 8 or less © ELAN Home Systems • 2003 • All rights reserved. 2/03 Page 15... - Page 16 Zone volume and system source matching volume controls. Automation Card Optional 630, TV IR Emitters or System 6 Automation Card © ELAN Home Systems • 2003 • All rights reserved. 2/03 Page 16...