Ir Expansion Port Connection; All Zones Ir Out Connection; Source Input Connections - Elan M86A Installation Manual

E L A N
Figure 3-2: Connections to System Controller
© ELAN 2010 | All rights reserved.
System Controller Connections (Continued)

IR Expansion Port Connection

The IR Expansion Port connection allows the System Controller to send SOURCE IR
commands to the M86A to be routed to the SOURCE IR OUTPUTS of the M86A. This
connection uses a DB-15 Male to Female cable (included with the M86A) from the IN IR
Expansion Port of the M86A to the IR LINK connection of the System Controller.

All Zones IR Out Connection

The All Zone IR Out connections allows IR commands received by the M86A (from a TS2's
IR receiver, for example) to be routed to the System Controller. These commands can be
used to trigger Event Maps that have been set up in the ELAN configuration software and
programmed into the System Controller. This connection uses a 3.5mm Stereo cable.

Source Input Connections

The HC6 and the HC12 have RCA line-level audio outputs for their Internal Players. These
must be connected to the Source Audio Inputs of the M86A if the Internal Players are going
to be used as sources. This connection uses standard RCA cables.
M86A
INSTALLATION MANUAL
Page 19