Equipment Set-Up; Accessories; Usage Of External Usb Devices; Your Receiver - Strong PrimaSat II User Manual

PART 1 • English

1.3 Equipment Set-up

We recommend you consult a professional installer to set up your equipment. Otherwise, please follow
the instructions below:
Refer to the user manual of your TV and your antenna.
„ „
Make sure that the SCART cable and outdoor components are in a good condition and the
„ „
SCART connection is well shielded
This manual provides complete instructions for installing and using this receiver. The following symbols
will serve as follow.
WARNING: Indicates warning information.
Tips: Indicates any other additional important or helpful information.
mENU
Move to

1.4 Accessories

1. User's Manual 1x
2. Remote control unit 1x
3. Batteries (AAA type) 2 x
The batteries should not be recharged, disassembled, electrically short-circuited, be mixed or used with
other types of batteries.
If rechargeable accumulators instead of batteries are going to be used, we recommend using (e.g.
NiMH) types with low self-discharge to ensure long time operation of remote control.

1.5 Usage of external USb devices

It is recommended to use USB 2.0 storage devices.
„ „
STRONG cannot guarantee compatibility to all types of USB storage devices.
„ „
It is advised not to store important information on USB storage devices used with the receiver.
„ „
Always make backups of data on USB storage device before usage with receiver. STRONG
will not take responsibility for any loss of information or circumstances caused by loss
of information.

2.0 YOUR RECEIvER

2.1 front Panel

1. INDICATION lED:
2. REmOTE SENSOR: Reception of remote control signals.
3. USb CONNECTION: Connection to USB storage device.

2.2 Rear Panel

1. SAT IN
Represents a button on the remote control or the receiver (bold Character)
Represents a menu item within a window. (Italic Character)
Green LED during operation, red LED in standby mode.
To connect to the LNB for satellite signal from dish
Fig. 1
Fig. 2
3