ATTACK DP STANDARD Instructions For Use Manual page 12

Required boiler temperature [C 80] - is temperature that the regulator tries to reach in the
operation mode. It is set by direct turning of button of the boiler thermostat and it is
indicated by short displaying.
Set temperature of the flue gas / room thermostat [100C] - this parameter indicates
temperature set by additional flue gas / room thermostat. In accordance to installation of
heating and setting of parameter FC (1 or 0) it represents the flue gas temperature (at lower
actual temperature, the regulator switches into the fuel shortage mode) or the room
temperature.
Actual flue gas temperature or room temperature [180°] - this parameter indicates actually
measured flue gas temperature or room temperature.
Setting of parameters – service menu
When the OK button is held for longer than 3 seconds, it is switched to the service mode,
where you can see and change programmed parameters. Service mode is indicated by
flickering of the additional thermostat´s control light. It is possible to browse parameters by
the + and - buttons. After selection of the required parameter you can switch into the mode
for parameter change by pressing of the OK button - this mode is indicated by flickering of
the parameter value. To change the value, use the + and - button. New setting can be
confirmed by the OK button. Then it is possible to select next parameter (by + and -). If you
wish to close service mode, select [END] by + and - and press OK or wait for 1 minute.
Devices finishes service mode and starts to display boiler temperature.
First column in the schedule represents display indications and in the next columns are:
parameter description, minimum value, maximum permitted value of setting, step of
parameter setting during adjustment, production settings to which it is possible to come by
selecting of the [Prod] option..
11