Cisco TES301 User Manual page 69

Internet Setup
Field
Internet Connection Type
Router Name
Host Name
Domain Name
MTU / Size
IGMP
4038767 Rev B
Description
The gateway supports five connection types:

Automatic Configuration DHCP (Default)—Select this
option to enable the DCHP server on your network to
assign an IP address to your gateway. This method
ensures that your gateway has a unique IP address within
range of the subnet.
Note: Your service provider may give you other
instructions to use any other option.

Static IP—Select this option if you want to manually
assign an IP address. If you select this option, you will
need to assign an unused address within range of the
subnet. When you select this option, the IP address of
your gateway will not be managed by the DHCP server.

PPPoE—Select this option if you want to configure your
gateway to use Point-to-Point Protocol over Ethernet
(PPPoE).

PPTP—Select this option if you want to configure your
gateway to use the Point-to-Point Tunneling Protocol
(PPTP).

L2TP—Select this option if you want to configure your
gateway to use the Layer 2 Tunneling Protocol (L2TP).
Displays the name of the gateway. This field is not
configurable.
The Host Name may be required by your service provider. If
so, use the value provided by the service provider; otherwise,
leave this field blank.
The Domain Name may be required by your service provider.
If so, use the value provided by the service provider;
otherwise, leave this field blank.
MTU is the Maximum Transmission Unit. It specifies the
largest packet size permitted for Internet transmission. Keep
the default setting, Auto, to have the gateway select the best
MTU for your Internet connection. To specify a MTU size,
select Manual, and enter the value desired (default is 1500).
You should leave this value in the 576 to 1500 range.
Enable this option if you do not wish to receive multicast
traffic that is sometime sent by your service provider.
Setup
51