Troubleshooting - Polar Electro FT1 User Manual

Training computer
Hide thumbs Also See for FT1:
Table of Contents

Advertisement

Available languages

Available languages

ENGLISH
Note that in addition to training intensity, medication for heart conditions, blood pressure, psychological
conditions, asthma, breathing, etc., as well as some energy drinks, alcohol, and nicotine may also affect
heart rate.
It is important to be sensitive to your body's responses during training. If you feel unexpected pain or
excessive fatigue when training, stop the training session or continue at a lighter intensity.
If you have a pacemaker, defibrillator or other implanted electronic device, you use the training computer
at your own risk. Before starting use, take a maximal training stress test under the supervision of a
physician. The test is to ensure the safety and reliability of the simultaneous use of the pacemaker and
the training computer.
If you are allergic to any substance that comes into contact with your skin or if you suspect an allergic
reaction due to using the product, check the listed materials in Technical Specifications . To avoid any
skin reaction to the transmitter, wear it over a shirt. Moisten the shirt well under the electrodes to ensure
flawless operation.
The combined impact of moisture and intense abrasion may cause a black color to come off the
transmitter's surface, possibly staining light-colored clothes.
If you use insect repellent on your skin, make sure that it does not come into contact with the transmitter
or the training computer.
Exercise equipment with electronic components may cause interfering stray signals.
To tackle these problems, try the following:
1.
Remove the transmitter from your chest and use the exercise equipment as you would normally.
2.
Move the training computer around until you find an area in which it displays no stray reading or does not
flash the heart symbol. Interference is often worst right in front of the display panel of the equipment,
while the left or right side of the display is relatively free of disturbance.
3.
Put the transmitter back on your chest and keep the training computer in this interference-free area as
much as possible.
If your training computer still does not work, the piece of equipment may be electrically too noisy for
wireless heart rate measurement.
Water Resistance of the FT1/FT2 Training Computer
FT1 and FT2 training computers may be worn when swimming. To maintain water resistance, do not press
the button under water. For more information, visit http://www.polar.fi/support. Water resistance of Polar
products is tested according to International Standard ISO 2281. Products are divided into three
categories according to their water resistance. Check the back of your Polar product for the water
resistance category, and compare it to the chart below. Please note that these definitions do not
necessarily apply to products of other manufacturers.
Marking on case back
Water resistant
Water resistant 30 m/50 m
WR 30M/WR 50M
Water resistant 100 m
WR 100M

Troubleshooting

If you've lost your way in the menu, press and hold the button until time of day is displayed.
14
Important Information
Water resistant characteristics
Protected against wash splashes, sweat, raindrops etc. Not suitable for
swimming.
Suitable for bathing and swimming
Suitable for swimming and snorkeling (without air tanks)

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Ft2

Table of Contents