DIAMOND™ D531
: code identifier enabled, no field adjustment, code length not
DATA FORMAT
transmitted, no header, terminator = CR, character replacement disabled.
WEDGE DEFAULT SETTINGS
USA keyboard, caps lock off, caps lock auto-recognition enabled, num lock
unchanged, inter-character and inter-code delays disabled, control character
emulation = ctrl+shift+key.
: code identifier disabled, no field adjustment, code length not
DATA FORMAT
transmitted, no header, terminator = ENTER, character replacement disabled.
POWER SAVE
stand by state enabled; enter stand by timeout 5 min.; sleep state enabled,
sleep state timeout 60 min.
READING PARAMETERS
Timeout between same code consecutive readings 0.3 sec, beeper intensity
high, tone 2, beeper type monotone, beeper length short, single line decoding
duration = 5 sec., timeout OFF before raster = 2 sec.
DECODING PARAMETERS
ink spread disabled, overflow control enabled, interdigit control enabled,
decoding safety = one read; code 39 stitching enabled, code 128 stitching
enabled.
CODE SELECTION
Enabled codes
•
EAN 8/EAN 13 / UPC A/UPC E without ADD ON
check digit transmitted, no conversions, autodiscriminate decoding
safety = 15 reads
•
Interleaved 2/5
check digit control and transmission, variable length code; 6-99
characters
•
Standard Code 39
no check digit control, variable length code; 4-99 characters
•
Code 128
variable length code; 1-99 characters
Disabled codes
EAN 128, ISBT128, Code 93, Codabar, MSI, Plessey, RSS
ADVANCED FORMATTING PARAMETERS
concatenation disabled, no advanced formats defined.
17