Fcc Compliance; Power Supply; Weee Compliance - Datalogic DIAMOND D531 Quick Reference

DIAMOND™ D531
COMPLIANCE

FCC COMPLIANCE

Modifications or changes to this equipment without the expressed written
approval of Datalogic could void the authority to use the equipment.
This device complies with PART 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference which may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

POWER SUPPLY

This device is intended to be connected to a UL Listed/CSA Certified computer
which supplies power directly to the reader or else be supplied by a UL
Listed/CSA Certified Power Unit marked "Class 2" or LPS power source rated
5 V, minimum 390mA, which supplies power directly to the reader via the power
connector of the cable.

WEEE COMPLIANCE

23