Rear Terminal - Sanyo PLC-ZM5000 Owner's Manual

①
① INFRARED REMOTE RECEIVER (Back)
The infrared remote receiver is also located in the
front and top (pp.10, 15).
② LAN CONNECTION TERMINAL
Connect the LAN cable (refer to the owner's manual
of "Network Set-up and Operation").
③ ANALOG OUT TERMINAL
This terminal can be used to output the incoming
analog RGB signal from INPUT 1-3 terminal to the
other monitor (pp.19-20).
④ ANALOG (COMPUTER INPUT TERMINAL)
Connect the computer (or RGB scart) output signal
to this terminal (pp.19-20).
⑤ AUDIO OUTPUT jACK (VARIABLE)
This jack outputs the audio signal from computer,
video, HDMI equipment or 5 BNC INPUT jacks to
external audio equipment (p.21).
⑥ R/C jACK
When using the wired remote control, connect
the wired remote control to this jack with a remote
control cable (not supplied) (p.15).
⑦ HDMI TERMINAL
Connect the HDMI signal (including sound signal)
from video equipment or the DVI signal from
computer to this terminal (pp.19, 20).
is registered trademarks of HDMI Licensing, LLC.
⑧ DIGITAL (DVI-D) TERMINAL
Connect the computer output digital signal to this
terminal. The HDTV (HDCP compatible) signal can
also be connected (pp.19-20).
 Kensington Security Slot
This slot is for a Kensington lock used to deter
theft of the projector.
*Kensington is a registered trademark of ACCO
Brands Corporation.

Rear Terminal

④
② ③
⑪
⑨ ⑩
Part Names and Functions
⑤ ⑥ ⑦
⑬ ⑭
⑫ ⑮
⑨ 5 BNC INPUT jACKS
Connect the component or composite
video output signal from video equipment
to VIDEO/Y, and Pr/Cr.jacks or connect the
computer output signal(5 BNC Type [Green,
Blue, Red, Horiz. Sync, and Vert. Sync.]) to
G, B, R, H/V, and V jacks (pp.19-20).
⑩ S-VIDEO INPUT jACK
Connect the S-VIDEO output signal from
video equipment to this jack (p.20).
⑪ VIDEO INPUT jACK
Connect the component or the composite
video output signal from video equipment to
these jacks (p.20).
⑫ AUDIO 3 jACKS (L(MONO)/R)
Connect the audio output (stereo) signal
from video equipment connected to INPUT
3 jacks (p.21). For a monaural audio signal
(a single audio jack), connect it to the L
(MONO) jack.
⑬ AUDIO 1 jACK
Connect the audio output (stereo) signal
from a computer connected to INPUT 1
terminals. (p.21)
⑭ AUDIO 2 jACK
Connect the audio output (stereo) signal
from 5 BNC INPUT jacks (INPUT 2 jacks).
(p.21)
⑮ CONTROL PORT CONNECTOR
When controlling the projector with RS-232C,
connect the control equipment to this
connector with the serial control cable (p.19).
⑯ USB CONNECTOR (Series B)
Use this connector when controlling a
computer with the remote control of the
projector. Connect the USB terminal of
your computer to this connector with a USB
cable (p.19).
⑧
⑯

11