Sanyo PLC-ZM5000 Owner's Manual page 60

Setting
Direct on
When this function is set to On, the projector will be
automatically turned on just by connecting the AC power
cord to the wall outlet.
Note:
Be sure to turn off the projector properly (see "Turning
Off the Projector" on page 24). If the projector is turned
off in the incorrect sequence, the Direct on function
does not work properly.
Pointer
You can emphasize a part of the projected image with this
function. Use the Point ▲▼ buttons to select a pattern of
the Pointer (Dot, Arrow or Finger). (p.32)
P-timer
This function allows you to change the presentation of the
P-timer and execute it.
Select one of the following options:
Count up ......... The P-timer display 000:00 appears on
the screen and the count starts (000:00–
180:00)
Count down .... The time set in the Timer setting appears
on the screen and the countdown starts.
Timer ............... Use the Point ▲▼ buttons to set the
Timer (1–180 Min). Only set to Count
down, Timer is active. Factory default
value is 10 Min.
Start ................ It executes the count up or count down
function. Press the SELECT button at
Start, Start changes to Stop in the
Screen Menu. At that time, press the
SELECT button at Stop to stop Count
up or Count down, and Stop changes
to Restart in the Screen Menu. Press
the SELECT button at Restart to resume
Count up or Count down.
Reset ............... Reset the P-timer values.
Press the SELECT button at Reset to
return to the following value;
Count up ........."000:00"
Count down ... Timer that you set.
Exit .................. To exit the P-timer operation.
Stop or Cancel the P-timer via Remote Control
To stop the P-timer, press the P-TIMER button.
To cancel the P-timer, press and hold the P-TIMER button
for a few seconds.
60
P-TIMER
P-timer display.