Auto Pc Adjustment - Sanyo PLC-ZM5000 Owner's Manual

Auto PC Adjustment function is provided to automatically adjust Fine sync, Total dots, Position H and
Position V to conform to your computer.
Direct Operation
The Auto PC adjustment function can be operated directly
by pressing the AUTO PC button on the remote control.
Menu Operation
Auto PC adj .
1 Press the MENU button to display the On-Screen
Menu. Use the Point ▲▼ buttons to select PC adjust
and then press the Point ► or the SELECT button.
Use the Point ▲▼ buttons to select Auto PC adj . and
2
then press the SELECT button.
To store the adjusted parameters:
The adjusted parameters from the Auto PC Adjustment
can be stored in the projector. Once the parameters are
stored, the setting can be done just by selecting Mode in
PC SYSTEM Menu (p.36). See "Manual PC Adjustment"
on pages 38-39.
Note:
• Fine sync, Total dots, Position H and Position V of
certain computers cannot be fully adjusted with the
Auto PC Adjustment function. When the image is
not provided properly with this operation, manual
adjustments are required. (pp.38-39)
• The Auto PC adjustment cannot be operated when
480i, 575i, 480p, 575p, 720p, 1035i, 1080i or
1080p is selected in the PC System Menu (p.36), or
when the signal is coming from the HDMI or DVI-D
terminal.
• Depending on the condition of signals and the
type and length of cables, the signals may not be
properly viewed.

Auto PC Adjustment

Computer Input
Remote Control
AUTO PC
button
PC adjust Menu
Use the Point ▲▼ buttons to
select Auto PC adj . and press the
SELECT button.
Please wait . . . appears while the
Auto PC adjustment is in process.
37