Rear Terminal - Sanyo LC-XBL20 Owner's Manual

Rear Terminal

①
① CONTROL PORT
When controlling the projector with RS-232C,
connect the control equipment to this connector with
the serial control cable.
②
COMPUTER IN 1 /S-VIDEO IN / COMPONENT IN
Connect analog RGB output signal from a
computer, S-VIDEO output signal from video
equipment, or RGB scart 21-pin video output or
component video output to this terminal (pp.14-16).
③
COMPUTER IN 2 / MONITOR OUT
– Connect analog RGB output signal from a
computer to this terminal (p.14).
– This terminal can be used to output the incoming
analog RGB and Component signal from
COMPUTER IN 1 /S-VIDEO IN /COMPONENT IN
terminal to the other monitor (pp.14,16).
② ③
④
AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.14-16).
This terminal outputs sound from AUDIO IN
terminal.
⑤
VIDEO IN
Connect the composite video output signal to this
jack (p.15).
⑥
LAN Connection Terminal
Connect the LAN cable (refer to the owner's
manual of "Network Set-up and Operation").
⑦
AUDIO IN
Connect the audio output signal from computer or
video equipment to this jack (pp.14-16).
Part Names and Functions
④
⑤ ⑥
⑦
9