Table of Contents
Advertisement
Quick Links
CPS Series
www.yamatocorp.com
Pocket Scale
Counting Feature
YAMATO CORPORATION
1775 S. Murray Blvd.
Colorado Springs, CO 80916 USA
Tel (719) 591-1500 Fax (719) 591-1045
Operation Manual
YAMATO TECH CORPORATION
#112-19425 Langley By-Pass
Surrey, B.C. V3S 6K1
Tel (604) 533-2338 Fax (604) 533-0827
Canada
YCO-1102-05-02
Advertisement
Table of Contents
Related Manuals for Yamato CPS series
Summary of Contents for Yamato CPS series
- Page 1 CPS Series Operation Manual Pocket Scale Counting Feature YAMATO CORPORATION YAMATO TECH CORPORATION 1775 S. Murray Blvd. #112-19425 Langley By-Pass Colorado Springs, CO 80916 USA Surrey, B.C. V3S 6K1 Canada www.yamatocorp.com Tel (719) 591-1500 Fax (719) 591-1045 Tel (604) 533-2338 Fax (604) 533-0827...
-
Page 2: Table Of Contents
CPS Series Operation Manual Table of Contents Name and Function of Parts Specifications III. Setup Installing the Battery Setting the Scale Functions Calibrating the Scale IV. Directions for Use Turning the Scale On and Off Low Battery Condition Zero the Display... -
Page 3: Name And Function Of Parts
CPS Series Operation Manual I Name and Function of Parts CPS-I Unit Count Tare 250 g x 0.1 g 8.8 oz x 0.005 oz Stable annunciator Indicates the displayed weight reading is stable. LCD Display Displays measured weight, units, number of items counted and status information. -
Page 4: Setup
CPS Series Operation Manual III Setup Installing the Battery The CPS uses two standard AAA alkaline batteries. The battery compartment is located under the scale towards the back of the scale. Press the cover in and out to open. Place the batteries into the battery compartment making sure they are aligned correctly with the polarity markings inside the compartment. - Page 5 CPS Series Operation Manual III Setup YCO-1102-05-02...
-
Page 6: Directions For Use
CPS Series Operation Manual IV Directions for Use Turning the Scale On and Off Remove everything from the platform surface, and press the key. The display will briefly perform a full segment display. After approximately three seconds, the display will automatically set to zero. -
Page 7: Gross Weighing
CPS Series Operation Manual IV Directions for Use Gross Weighing 1) Begin with no load on the scale and the display reading zero. 2) Place the item(s) to weighed on the scale platform. The weight displayed will be the gross weight. -
Page 8: Troubleshooting And Error Messages
CPS Series Operation Manual V Troubleshooting and Error Messages The scale can check various functions automatically. When a problem is detected, the following mes- sages will be displayed. If you take the steps described below but the problem is not fixed, the scale needs to be serviced by a qualified scale technician.