Fcc Statement; Fcc Part 15 Information - Pandigital PhotoLink PANSCN01 User Manual

this product is limited in duration to the duration of this warranty.
Some states do not allow the exclusion or limitation of incidental or consequential
damages, or allow limitation on how long an implied warranty lasts, so the above
limitations or exclusions may not apply. This warranty gives you specific legal
rights, and you may have other rights, which vary from state to state.
All content included on the Pandigital website as well as Pandigital products,
including preloaded demonstration images, digital media, digital cookbooks, text,
graphics, logos, designs, photographs, button icons, images, audio/video clips,
digital downloads, data compilations, and software, is the property of Pandigital or
its suppliers and is protected by United States and international copyright laws or
other intellectual property laws and treaties. Said content shall not be reproduced
or used without express written permission from Pandigital and its suppliers
respectively.
Use of this product constitutes acceptance of these terms and conditions of
warranty.

FCC Statement

FCC Part 15 Information

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the Federal Communication Commission
(FCC) Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected. • Consult the dealer or an experienced radio/TV
technician for help.
"WARNING: Changes or modification to this unit not expressly approved by the
party responsible for compliance could void the user's authority to operate the
equipment"
25