Powering Up The Photolink Scanner; Making A Photo Scan - Pandigital PhotoLink PANSCN01 User Manual

Powering Up the PhotoLink Scanner

Making a Photo Scan

5. Press the Power button. The Power indicator
blinks.
Note: For more information on the indicators,
see "indicators" on page 8.
6. Wait until the Power indicator stops blinking
and then goes off. The Status/ card indicator
will light up instead, indicating that the scanner
is ready.
Note: Do not insert an original photo into the
feeding slot when the Power indicator is blinking.
The original photo will not be scanned.
1. With the side to be scanned facing upward and
in correct orientation as indicated by the
orientation mark, place one edge of the origin
on the scanner and adjust the guide lever so
that the original photo aligns against the left
side of the feeding slot.
Insert the original photo into the feeding slot.
WARNING: Do not scan glossy photos in
humid environments (humidity higher than 70%
RH). Otherwise the surface of the photo will
become sticky and cause the scanner to jam.
al
10