Pandigital PhotoLink PANSCN01 User Manual page 23

and calibration? Refer to "Cleaning the scanner" on page 19 and
Calibrating the scanner" on page 21 to clean and calibrate the
scanner and then try again.
Q: The original gets stuck halfway in the feeding slot.
A: Press the Power button. The scanner will advance the original so you can
remove the jammed original from the output slot.
Q: The status indicator blinks rapidly and no scan is possible.
A: Check the following:
Is the memory card inserted properly into the memory card slot? Re-
insert the card and try again.
Is the SD card locked (set to write-protect)? Unlock the card.
Is the memory card full? The indicator blinks when the free space on
the memory card is below 3MB. Use another card if necessary.
Is the memory card in NTFS or other file formats? The scanner only
accepts memory cards in FAT or FAT32 file format.
Did you insert the next original before the scanning process of the
previous one is completed? Power off and then on the scanner and try
again. Make sure that you scan the next original only after the
scanning process of the previous one is completed
Does the length of the original exceed the maximum acceptable size?
Refer to "Suitable and unsuitable types of originals" on page 16 for
more information.
Q: The scanner feels warm to the touch.
A: It is normal for the scanner to emit a small amount of heat (around 30-45
Celsius) after prolonged use. However, if there are strange odors coming
out from the scanner or the scanner feels hot to the touch, disconnect the
scanner immediately from the power supply or the computer/ digital photo
frame.
Q: The "scan to digital photo frame" function does not work.
A: This function only works with compatible digital photo frames. Visit
www.pandigital.net for a list of compatible digital photo frame
products.
23