Replacing The Headlamp - Lionel Rotary Snowplow Owner's Manual

Maintaining and servicing your
Rotary Snowplow

Replacing the headlamp

Y our Rotary Snowplow features an operating headlight. During the course of normal opera-
tion, this lamp may require replacement. The lamp is Lionel part no. 610-8446-100,
available from your authorized Lionel Dealer. Follow these steps and refer to Figure 6 on page
11 as you replace this lamp.
1. Remove the two screws that secure the Snowplow's body shell to the frame and carefully lift
the shell away from the frame.
As illustrated in Figure 3, these screws are located on opposite ends of the body. One is at
the left front corner behind the impeller housing; the other is at the rear right corner.
2. Follow the two wires that emerge from the impeller housing to the two-pin connector on
the circuit board.
3. Pull out the top portion of the two-pin connector.
4. Use a pointed tool to pry open the white tabs and pull out the two wires as illustrated in
Figure 6.
5. Remove the wires by pulling them through the snowblower housing and the lens opening.
6. Feed the replacement lamp wires back through the lens opening and snowblower housing.
7. Insert the wires into the top portion of the connector, then plug the connector back into the
circuit board.
8. Press the lens assembly securely into place.
9. Replace the body shell, tightening the two cab mounting screws.
10