Table of Contents
Advertisement
Quick Links
73-1953-250
4/03
Lionel
Ready-to-Run
Riding the Rails Hobo Train
Owner's Manual
CAUTI O N—ELECTRI C TOY
NOT RECOMMENDED FOR CHILDREN UNDER EIGHT YEARS OF AGE. AS WITH
ALL ELECTRIC PRODUCTS, PRECAUTIONS SHOULD BE OBSERVED DURING
HANDLI N G AND USE TO REDUCE THE RI S K OF ELECTRI C SHOCK.
TRANSFORMER RATINGS—I N PUT:120 VAC; 60 HZ ONLY.
AC OUTPUT:18 V; 80 VA
Advertisement
Table of Contents
Related Manuals for Lionel Ready-to-Run Riding the Rails Hobo Train
Summary of Contents for Lionel Ready-to-Run Riding the Rails Hobo Train
- Page 1 73-1953-250 4/03 Lionel Ready-to-Run Riding the Rails Hobo Train Owner’s Manual CAUTI O N—ELECTRI C TOY NOT RECOMMENDED FOR CHILDREN UNDER EIGHT YEARS OF AGE. AS WITH ALL ELECTRIC PRODUCTS, PRECAUTIONS SHOULD BE OBSERVED DURING HANDLI N G AND USE TO REDUCE THE RI S K OF ELECTRI C SHOCK.
- Page 2 In the event that such conditions exist, the transformer should not be used until properly repaired. The following Lionel marks may be used throughout this instruction manual and are protected under law. All rights reserved. Lionel ®...
-
Page 3: Table Of Contents
Hobo Campfire operations Connecting the Hobo Campfire accessory Installing the Hobo Campfire accessory Operating the Hobo Campfire accessory Train operations Running your locomotive with a Lionel transformer Reverse unit procedure Tire-Traction Coupling Operating your handcar Maintaining and servicing your set... -
Page 4: Track Layout
Track layout Building your Lionel layout our set comes with eight curved, three straight, and one power terminal section of track. Figure 1 provides some examples of layouts that you can build with these track sections. By adding more FasTrack track sections, you can create an endless number of exciting track arrangements for more fun, action, and variety. -
Page 5: Controller Operations
• Parents should periodically inspect this product for potential hazards and, if necessary, have them repaired by an authorized Lionel Service Center. In the event that such a condition exists, the transformer should not be used until it has been properly repaired. -
Page 6: Wiring Your Cw-80 Transformer
Controller operations Wiring your CW-80 Transformer or best performance on large layouts, it is recommended that you use 16-gauge wire to connect your CW-80 Transformer to the track. Connect the spade connectors on the wires from the FasTrack terminal section. On larger layouts where several track connections are required, the use of separate junctions/terminal strips (available at your local electronics store) is recommended to prevent voltage drops. -
Page 7: Advanced Connections: Powering Two Isolated Blocks With Two Transformers
Controller operations Advanced connections: powering two isolated blocks with two transformers s you expand your layout, you may decide to create two isolated blocks of track. Trains in each block are controlled by separate transformers. Before you operate you trains on this type of layout, be sure that your transformers are in phase. -
Page 8: Experiencing The Features Of The Cw-80 Transformer
To correct this problem, simply turn off the CW-80 Transformer, then turn it back on. The CW-80 Transformer may cause random whistles in the Lionel Mighty Sounds of Note! Steam tenders with a three-pin connector. -
Page 9: Experiencing The Features Of The Cw-80 Transformer
CW-80 is on. Whistle/Horn Activates the whistle or horn sound Throttle effect in your Lionel locomotives. Controls your locomotive’s speed. Throw the throttle Press WHISTLE/HORN to begin the forward to increase locomotive speed, backward to slow sound; release the button to end it. -
Page 10: Setting The Accessory Output
Controller operations Setting the accessory output ake control of your Lionel empire with your CW-80 Transformer! You choose how much power your accessories need. Your CW-80 Transformer features a programmable accessory output. The ability to control the voltage allows you to set the speed of your accessory motors and the intensity of your lights. -
Page 11: Powering Your Layout With The Cw-80 Transformer
Controller operations Powering your layout with the CW-80 Transformer our CW-80 Transformer provides a total output of five amps. The track outputs will deliver all of this power to the track when no accessories are connected to the Transformer. Keep in mind that connected accessories borrow some of this power. -
Page 12: Troubleshooting
Controller operations Troubleshooting No lights or operation Be sure CW-80 Transformer is plugged in. Train runs, but WHISTLE/HORN, BELL, and DIRECTION buttons do not work Check track connections. The track must be connected to the “A” and “U” terminals on the Transformer. -
Page 13: Hobo Campfire Operations
Hobo Campfire operations Connecting the Hobo Campfire accessory onnect the Hobo Campfire accessory to your CW-80 Transformer’s accessory terminals. Use the two wires included with the campfire accessory to make these connections. To make the proper contact, an adult should strip back the insulation 1/8” to 1/4” if the wires are not already stripped. -
Page 14: Installing The Hobo Campfire Accessory
Hobo Campfire operations Installing the Hobo Campfire accessory ou may choose to install the Hobo Campfire on your layout in three ways. First, you may choose to set the accessory on your layout without securing it in place. If you are not using the mounting tabs of the side of the base, you may carefully snap them off. -
Page 15: Operating The Hobo Campfire Accessory
Your campfire is illuminated by two LEDs. The LEDs are expected to last for the life Note! of this accessory. Should service ever become necessary, refer to the Limited Warranty/Lionel Service section at the end of this manual. Figure 8. ON/OFF switch... -
Page 16: Train Operations
Move ‘em out! • Get your locomotive moving. Press the DIRECTION button on your Lionel transformer. This advances the Lionel reverse unit to the next operating state in the repeating sequence: forward, neutral, reverse, and neutral. • Adjust track voltage until your locomotive moves at your desired speed. To increase speed, increase track voltage. -
Page 17: Reverse Unit Procedure
Reverse unit procedure he electronic reverse unit inside your of the locomotive), the locomotive will be Lionel locomotive acts like the locked in the next mode of operation in the transmission in your car. When you apply sequence. For instance, if the locomotive is... -
Page 18: Tire-Traction
Replacement traction tires tire to enhance tractive effort so your are available at your authorized Lionel Service locomotive can pull many cars at once. Center. Coupling... -
Page 19: Operating Your Handcar
Maintaining and servicing your set Operating your handcar lace your handcar (illustrated in differently, one unit will eventually catch up Figure 13) on the track and power up. to the other. Avoid collisions to prevent You will find that the handcar goes in only damage and always be ready to turn off one direction. -
Page 20: Lubricating Your Steam Locomotive
Figure 14 below. Remove accumulated dirt Maintenance Kit (6-62927), available from and dust before lubricating, and always your Lionel dealer. Two basic rules to keep in lubricate any locomotive emerging from mind: never over-lubricate (a small amount prolonged storage. Also, lightly lubricate the will do), and avoid getting grease or oil on steam locomotive’s side rods after every ten... -
Page 21: Lubricating Your Handcar
After 10 to 12 hours of operation, the dry, and free of oil and grease. Clean axles will require a drop of Lionel oil or rust and dirt spots with fine sandpaper, then other light machine oil. Do not lubricate wipe the track with a clean soft cloth excessively. - Page 22 During the available from your authorized Lionel Service course of normal operations, the lamp may Center or Lionel Service. See the Lionel Service require replacement. section on page 24 for more information. Carefully remove the three cab screws (see Remove the expired lamp by unscrewing it page 20 for their locations).
-
Page 23: Replacing Your Square Window Caboose's Lamp
4. Pull the lamp straight up and out of the socket. Replace it with Lionel lamp no. 600-8352-311, available at your authorized Lionel Service Center or Lionel Service. -
Page 24: Limited Warranty/Lionel Service
Center, together with proof of original purchase above instructions carefully before returning any will, at the option of Lionel L.L.C., be repaired or merchandise for service. You may choose to have replaced, without charge for parts or labor. In the...
Need help?
Do you have a question about the Ready-to-Run Riding the Rails Hobo Train and is the answer not in the manual?
Questions and answers