Replacing Your 4-4-2 Locomotive's Headlamp - Lionel New York Central Flyer Owner's Manual

Maintaining and servicing your set

Replacing your 4-4-2 locomotive's headlamp

Y our 4-4-2 locomotive lights the way with its operating headlight. During the course of
normal operations, the lamp may require replacement. Refer to Figure 13 as you replace
the lamp.
1. Remove the two front truck screws and carefully slide the front truck assembly off the link-
age rods.
2. Lift the smoke unit out far enough from the cab to allow lamp extraction.
3. Pull the lamp straight out and replace it with Lionel part no. 600-0161-300, available from
your nearest authorized Lionel Service Center or from Lionel Service. Be careful not to twist
the lamp or it may break.
4. Reinstall the smoke unit, making sure that the smoke stack lines up with the cab top opening.
5. Reassemble the front truck, making sure that the linkage rods go into the holes in the
front truck. The lug wire from the smoke unit must be reinserted through the slot in the
front truck assembly and secured under one of the two front screws. Tighten the screws
firmly, but do not over-tighten them.
Front truck
screws
Figure 13. Headlight replacement
Linkage rods
23
Smoke unit
Lionel part no.
600-0161-300
Smoke unit
lug wire