Arctic Cat Bearcat 570 2012 Operator's Manual page 59


NOTE: On the LTD model, also
remove the two pins securing the
third seat to the seat/Speedrack
mount; then lift the third seat up and
away.
2. Lift on the back of the rear seat and
move rearward to remove it from the
mount.
3. Compress the latch on the right side
of the front seat and lift the front seat
away; then disconnect the taillight
harness connector.
4. Loosen (but do not remove) the
three right-side
mount cap screws.
5. Carefully route the harness connec-
tor through the hole in the storage
compartment panel; then remove the
harness from beneath the seat/Spee-
drack mount.
6. Remove the two self-tapping screws
securing the taillight to the bumper;
then route the harness out of the
bumper and remove the taillight.
7. Route the taillight harness through
the bumper; then secure the taillight
to the bumper with the two self-tap-
ping screws.

the third seat into position on the
mount making sure the two pin holes
0745-131
are properly aligned with the mount-
ing location on the mount; then
install the two pins making sure they
are properly seated.
Make sure the rear seat (and on the
LTD model, the third seat) is securely
locked in place with the pins before
carrying a passenger or personal
injury may result.
Removing and Installing
Taillight/Brakelight Bulb
(Bearcat 570/T570/TZ1
Models)
743-444A
seat/Speedrack
8. Carefully route the harness beneath the
Speedrack mount and through the hole
in the storage compartment panel; then
connect the harness connector.
9. Tighten the three right-side mount
cap screws; then lower the front seat.
10. Place the rear seat into position on
the mount making sure the four pin
holes are properly aligned with the
mounting location on the mount.
11. Install the four pins making sure
they are properly seated.
NOTE: On the LTD model, place
! WARNING
1. Remove the torx-head cap screws
securing the taillight access panel.
2. Disconnect the harness connector
and remove housing.
3. Push in on the socket and rotate it
counterclockwise to remove it from
the housing.
4. Remove the old bulb by pulling it
straight out of the socket.
742-467A
55