Air Filter - Technibel MRAF98C5T Series Operating Instructions Manual

AIR FILTER

The filter behind the air intake grille should be checked and
cleaned at least once every two weeks. (MRAF-MPAF-
KPAF MODELS)
MRAF-MPAF MODELS
HOW TO REMOVE THE FILTER
Air intake grille
1. Grasp both ends of the air intake grille and pull it towards
you and up.
2. Push the filter up slightly, and then pull it down. Clean the
air filter.
HOW TO REPLACE THE FILTER
Insert into the groove on the unit
1. With the «FRONT» mark facing you, slide the filter up
into the unit and then lower the handler into the groove
on the unit.
2. After installing the filter, press the locations marked by
the arrows ( ) and close the air intake grille.
KPAF MODELS
HOW TO REMOVE THE FILTER
1
2
1.Grasp both ends of the air intake grille and pull to open
it.
2.Hold the air filter by the tab and pull it upward. Clean the
air filter.
3.When replacing the filter, make sure that the FRONT
mark is facing you. Reinsert the filter into place and close
the air intake grille.
CAF MODELS
The air filter should be cleaned at least once every six
months or more frequently; it depends on the real operation
conditions.
HOW TO REMOVE THE FILTER
Air filter
L AT C H
1.Remove the screw on each side out of the latch using a
screwdriver.
2.Press on the two latches of the air intake grille with your
Air intake
thumbs in the direction of the arrow to open the grille.
grille
3.Open the air intake grille downward.
4.Remove the air filter from the air intake grille. Clean the
air filter.
5.Insert the filter correctly again inside the grille, close the
grille letting the latches slide toward the outside and fix
Air filter again the latch with the screw on both sides.
FILTER CLEANING
Use a vacuum cleaner to remove light dust. If there is
sticky dust on the filter, wash the filter in lukewarm, soapy
water, rinse it in clean water, and dry it.
3
11
SCREW
AIR INTAKE GRILLE
GB
AIR FILTER