Enter the Bypass output setting interface.Press and hold the
②
function setting key
seconds), then come to setting interface of bPS, at this time, the
letters "bPS" will light for a long time. The "ON" below the bPS
will flash. Press and hold the inquiring key
a second (less than 2 seconds) to determine whether the bPS function
is used or not. If used, the corresponding word is "ON", if not,
the word is "OFF". It can be determined by yourself.
Confirm the Bypass output setting interface. After selecting ON or
③
OFF, press and hold the function setting key
seconds. Now, the bPS setting function is completed and the "ON"
or "OFF" below the "bPS" will light without flash.
Exit from the setting interface. Press and hold function setting
④
key
for more than 2 seconds, exit from the setting interface
and return to main interface.
After setting bPS as ON, when mains power plugged in without turning
⑤
on the UPS or no mains power plugged in, there is bypass output but
no power down backup function.
5.3.3 Output voltage setting (optional function)
Enter the setting interface.Press and hold the function setting key
①
for more than 2 seconds, then come to setting interface, Press
and hold the function setting key
second(less than 2 seconds), select the function setting, choose
the output voltage setting interface, at the moment, the letters
"OPU" will flash as following:
for more than half a second(less than 2
19
for more than half
for more than 2
for more than half a