Eaton RT 1250VA User Manual page 14

4.6.3 Tower/Rack assembly
Fig 14 Tower－mounted assembly
Warning:
★ Before installing battery, make sure that UPS and breaker are all turned off.
Remove all your metallic adornment such as finger ring, watch, and so on
before connecting battery.
★ No anti-connection or short circuit between the battery anode and cathode
forever. Red cable connect with battery anode "+" and black cable connect
with cathode "-".
★ Please use the screwdriver with insulating handle. Do no lay the tools or
metallic goods on the battery.
Notice:
★When using the external battery, It is best to use external battery cable which
matches with the equipment.
★When connecting load to UPS, first turn off load and then connect the power
cable and finally turn on load one-by-one.
★Inductance loads such as motor, fluorescent lamp, copy cat are strictly
prohibited connecting to UPS to avoid damage.
★Plug UPS on the special socket with over-current protection, the power socket
that used should be connected with ground wire.
★UPS is likely to have output voltage no matter whether the power input cable is
plugged in mains input socket. If you wish UPS have no output, first break off
the switch and then cancel the mains.
★When connect laser printer, select the capacity of UPS according to the UPS
start power because the startup power is higher.
Fig 15 Rack－mounted assembly
12