Page 4
Rice Lake continually offers web-based video training on a growing selection of product-related topics at no cost. Visit www.ricelake.com/webinars.
Do not operate or work on this equipment unless you have read and understand the instructions and warnings in this manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Rice Lake Weighing Systems dealer for replacement manuals. Proper care is your responsibility.
RS-130 Retail Scale Calibration Instruction Sheet Procedures described require work inside the scale enclosure. These procedures are to be Warning performed by qualified service personnel only. Weight Calibration Follow the steps below to complete the calibration process. 1. Turn on power and press and hold the...
Page 8
2. Tighten the four screws into the base of the scale. 3. Replace the lead seal in the center of the base, over the sealing pin. 4. Replace the platter and plastic in-use cover. Sealing Pin Figure 2-2. Sealing Pin RS-130 Operation Manual...
The following section describes the front panel keys, annunciators, and display functions (displayed in Figure 3-1 on page 6) of the . Key functions are described in Table 3-1 below. To turn on the scale, toggle the On/ RS-130 Off switch located on the bottom of the scale.
Status of battery charging Red: initial charge Orange: charging Green: fully charged Figure 3-1. Front Display Annunciators Error Messages Table 3-3 describes error messages that may be shown on the RS-130 display. Display Description Corrective Action WEIGHT IC93C66 data-loss or IC93C66 damaged/...
RS-130 Limited Warranty Rice Lake Weighing Systems (RLWS) warrants that all RLWS equipment and systems properly installed by a Distributor or Original Equipment Manufacturer (OEM) will operate per written specifications as confirmed by the Distributor/OEM and accepted by RLWS. All systems and components are warranted against defects in materials and workmanship for one year.