Speedometer/Lcd (Analog/Digital) - Arctic Cat 450 i Operator's Manual

Condition Warning Display - Uses odom-
eter/trip meter display of the LCD to
warn of a system error condition requir-
ing attention.
A. Volt - The LCD will go blank
except the word VOLT will flash
on the LCD whenever a low volt-
age (< 9 DC volts) or a high volt-
age (> 16 DC volts) is detected.
When voltage returns to normal,
the gauge must be reset by turning
the ignition key to the OFF posi-
tion and then to the ON position.
B. EFI - On the 550/700 models, the
LCD will go blank except the let-
ters EFI will flash on the LCD
whenever an electronic fuel injec-
tion error is detected. After 30
seconds, the LCD will return to
normal; however, the letters EFI
will continue to flash until the
cause of the error is corrected.
C. EFI - On the 450/1000 models, the
LCD will go blank except a mal-
function code will flash on the
LCD and a wrench icon will be dis-
played whenever an electronic fuel
injection malfunction is detected.
After 30 seconds, the LCD will
return to normal; however, the mal-
function code and wrench icon will
continue to be displayed until the
malfunction is corrected.

NOTE: Take the ATV to an autho-
rized Arctic Cat ATV dealer to have
the EFI error corrected and to have
the ECU reset as soon as possible.
Speedometer/LCD
(Analog/Digital)

NOTE: All segments of the LCD
will activate for approximately two
seconds when the ignition switch is
rotated to the ON position.
54
1. Clock/Engine Hour Meter - The clock
function indicates time in the 12-hour
mode; the hour meter indicates the
total time the ATV has run and cannot
be reset to zero. To set the clock, use
the following procedure.
A. With the ignition switch ON,
press and release the Mode But-
ton (3) until the Clock/Engine
Hour Meter (1) is displayed; then
(if necessary) press and release
the Set/Reset Button (4) to select
the clock display.
B. Press and hold the Set/Reset But-
ton (4) until the minutes stop
scrolling and the hour display
starts to scroll. Momentarily
release when the correct hour is
displayed; then repeatedly press
and release the Set/Reset Button
(4) until the correct minutes are
displayed.

NOTE: Clock memory power is
supplied through the 15-amp acces-
sory fuse and verified during gauge
"power-up" and reset. In the event of
clock memory power failure (blown
fuse, etc.), the gauge will "power-
up," reset, and shut down repeatedly
until clock memory
restored. Always check the 15-amp
accessory fuse if this gauge condi-
tion is noted.

NOTE: The engine hour meter will
not activate until engine speed
exceeds 500 RPM.
2. Fuel Level Indicator - Indicates
approximate amount of gasoline in
the gas tank.
CF094A
power is