Table of Contents
Advertisement
2. Temperature Indicator - If the engine
coolant temperature exceeds the nor-
mal operating range, the temperature
icon will begin flashing and the LCD
will go blank for 30 seconds; then the
LCD will return to normal. However,
the temperature icon will continue to
flash.
CAUTION
Continued operation with high engine
temperature may result in engine
damage or premature wear.
NOTE: High engine RPM, low vehi-
cle speed, or heavy load can raise
engine
temperature.
engine RPM, reducing load, and
selecting an appropriate transmis-
sion gear can lower the temperature.
NOTE: Debris in front of the
engine (or packed between the cool-
ing fins of the radiator) can reduce
cooling capacity. Using a garden
hose, wash the radiator and the
engine to remove any debris restrict-
ing air flow.
CAUTION
Arctic Cat does not recommend
using a pressure washer to clean the
radiator core. The pressure may bend
or flatten the fins causing restricted
air flow, and electrical components
on the radiator could be damaged.
Use only a garden hose with spray
nozzle at normal tap pressure.
3. Mode Button - Shifts the gauge
through three set-up modes: speed-
ometer/tachometer,
time.
NOTE: The Mode Button must be
pressed and released to shift modes.
Approximately two seconds after the
Mode Button is released, the digital
gauge will return to full display.
4. Set/Reset Button - In conjunction
with the Mode Button, sets and resets
various displays on the digital gauge.
Also used to shift from speedometer
function to tachometer function on
the speedometer/tachometer gauge.
5. Fuel Level Indicator - Indicates
approximate amount of gasoline in
the gas tank.
NOTE: When the bottom segment
flashes, approximately 3.5 L (0.92
U.S. gal.) of gasoline remains in the
tank.
6. Low Oil Pressure - Will be displayed
during self-test at start-up. It will not
be displayed during normal operation
as oil pressure is not monitored on
these models.
7. Odometer/Trip Meter - Odometer
registers the total distance the vehicle
has traveled. The trip meter is
Decreasing
resetable and can be used to measure
trip or trip legs. The odometer cannot
be reset.
NOTE: To shift between the odom-
eter (ODO) or trip meter (TRIP), press
the Mode Button (3) to select the dis-
tance mode; then press the Set/
Reset Button (4) to select the desired
display. Hold the Set/Reset Button
down to reset the trip meter.
8. Gear Position Indicator - Indicates
which gear position is selected.
• R (reverse)/N (neutral)/L (low range)/H
(high range)
NOTE: An E will be displayed if
there is an error caused by a no-shift
position signal.
9. High Beam Indicator - The High
Beam icon will appear only when the
headlights are on high beam.
10. 4WD Lock Indicator - Displays
distance,
and
LOCK when the front differential
lock has been engaged.
11. Drive Select Indicator - Displays 4WD
when selected by the drive select switch
or when the 4WD lock is engaged. The
display is blank when in 2WD.
12. Speedometer - Indicates the approxi-
mate vehicle speed in miles per hour
(MPH) or kilometers per hour (km/h).
NOTE: To change mph/km/h dis-
play, press and release Mode Button
(3)
until
appears; then press the Set Button
(4) to change the display.
the
icon
(MPH/km/h)
53
Hide quick links:
Advertisement
Table of Contents
