Speedometer/Lcd (Analog/Digital) (550 Limited) - Arctic Cat 2013 400 TRV Operator's Manual

10. 4WD Lock Indicator - Displays
LOCK when the front differential
lock has been engaged.
11. Drive Select Indicator - Displays 4WD
when selected by the drive select switch
or when the 4WD lock is engaged. The
display is blank when in 2WD.
12. Speedometer - Indicates the approxi-
mate vehicle speed in miles per hour
(MPH) or kilometers per hour (KPH).
 NOTE: To change mph/km/h dis-
play, press and release Set Button
(4) until the icon
appears; then press and hold the
Set Button (4) to change the display.
Condition Warning Display - Uses odom-
eter/trip meter display of the LCD to
warn of a system error condition requir-
ing attention.
A. Volt - The LCD will go blank
except the word VOLT will flash
on the LCD whenever a low volt-
age (<9 DC volts) or a high volt-
age (>16 DC volts) is detected.
When voltage returns to normal,
the gauge must be reset by turning
the ignition key to the OFF posi-
tion and then to the ON position.
B. EFI - On the 550, the LCD will go
blank except the letters EFI will
flash on the LCD whenever an elec-
tronic fuel injection error is
detected. After 30 seconds, the LCD
will return to normal; however, the
letters EFI will continue to flash
until the cause of error is corrected.
 NOTE: Take the ATV to an autho-
rized Arctic Cat ATV dealer to have
the EFI error corrected and to have
the ECU reset as soon as possible.
Speedometer/LCD
(Analog/Digital) (550
Limited)
(MPH/KPH)
1. Clock/Engine Hour Meter - The
clock function indicates time in the
12 hour mode; the hour meter indi-
cates the total time the ATV has run
and cannot be reset to zero. To set the
clock, use the following procedure.
A. With the ignition switch ON,
press and release the Mode But-
ton (3) until the Clock/Engine
Hour Meter (1) is displayed; then
(if necessary) press and release
the Set/Reset Button (4) to the
clock display.
B. Press and hold the Set/Reset But-
ton (4) until the minutes stop
scrolling and the hour display
starts to scroll. Momentarily
release when the correct hour is
displayed; then repeatedly press
and release the Set/Reset Button
(4) until the correct minutes are
displayed.
 NOTE: Approximately two seconds
after releasing either Button, the LCD
will return to normal operation.
 NOTE: Clock memory power is
supplied
accessory fuse and verified during
gauge "power-up" and reset. In the
event of clock memory power fail-
ure (blown fuse, etc.), the gauge
will "power-up," reset, and shut
down repeatedly until clock mem-
ory power is restored. Always
check the 15-amp accessory fuse
if this gauge condition is noted.
CF094A
through the 15-amp
55