Programmable Key - ATCOM AT840 User Manual

AT840 Series User Manual
Outside Dial Tone：An alternative to <Dial Tone> usually used to prompt the user to enter an

external phone number (versus an internal extension). This is triggered by a "," character
encountered in the dial plan.
Busy Tone：Played when a 486 RSC is received for an outbound call.

Reorder Tone：Played when an outbound call has failed or after the far end hangs up during

an established call.
Off Hook Warning Tone: Played when the subscriber does not place the handset on the cradle

properly.
Ring Back Tone：Played for an outbound call when the far end is ringing.

MWI Dial Tone：This tone is played instead of <Dial Tone> when there are unheard messages

in the subscriber‟s mail box.
Holding Tone：Indicate to the local user that the far end has placed the call on hold.

Conference Tone：Plays to all parties when a Three way conference is in progress.


5.7. Programmable key

Event:

None: Do not use this BLF key

Hold: hold a call

Xfer: transfer a call

Conf: make 3 way conference

DND: Do not disturb(can make call but can not receive call).

CFWD: call forward

Speed dial: Speed dial, need to fill a speed dial number.

BLF: Busy lamp field, need to fill a BLF number to monitor.

When the BLF number is ringing , the BLF key will turn to red and blink.
When the BLF number is during a call, the BLF key will stay for red.
The BLF key will be yellow, if the BLF number is idle. And you can press the Key
the number(like speed dial).
CallPickup: Pick up the sb's call which in the same pickup group.

NAM TRUONG GIANG
www.lapdattongdaidienthoai.com
to call
33