Sub-Zero 601R Installation Instructions Manual page 10

BUIL%IN INSTALLATION INSTRUCTIONS
AM"['I-"['IP BLOCKING KIT POSITION THE UNIT
To p_eve_%_ the lll!t from tippi_g fe!waid
mist be seelred ! place witl_ a_} a_lislip
!
bleeIi_g
de!ice:
Prot{_÷t
anv :!_ished
f!ooring
before
movillg the _.ll_it ilte plaee. A!l Built÷Ir_
i _Oile!s ®ie iq/ipl}el with rillei s) sO vii
@ti eiiil ! riiie _t111 iiil
illt/itslacii
If there is a solid soffit above the unit with
clearance between the unit and the soffit of 1""
(2B) or less, you won't need to block the unit.
Refer to illustration B below. For installations
with clearances of more than 1" (25), you must
block the unit with the anti-tip blocking kit
(wood block and hardware) provided.
Locate and mark two wall studs against the
wall where the Built-in unit will be installed.
Then locate the proper height to Near the unit.
The space between the unit top and the
bottom of the wood block must not be more
than 1/4"' (6}.
Position the wood block over the unit and use
the screws and 'L' brackets to lock it in place.
Make sure the screws extend a minimum of
7/s" (22) into each of the two wall studs. The
wood block must be positioned securely and
must extend at least 3" (76) over the unit. Refer
to illustration 6 below.
Shut off power to the wail outlet. Plug the
power supply cord into the 15 amp grounded
outlet and roll the unit into position under the
wood block or soffit. Using the front and rear
leveling legs, raise the unit until it makes
contact with the wood block. See Level the
Unit, page 11.
iMPORTANT NOTE: If possible, keep door(s)
dosed on the unit until it is properly anchored.
iMPORTANT NOTE: If for any reason the unit
has been laid on its back or side, you must
allow the unit to stand upright for a minimum
of 24 hours before connecting power.
dppk_g Ie_wa_6 the f_o_t k+velk_g !÷gs
m_st
beir_
coK_act Wit_'l the floo_.
'0