Installation Instructions - RAIS PALO User Manual

ENGLISH

Installation instructions

The following pages give instructions for the safe and proper installation of this heating ap-
pliance in the UK. These instructions cover the basic principles of installation, although detail
may need slight modification to suit particular local site conditions. In all cases the installa-
tion must comply with current UK Building Regulations, Local Authority Byelaws and other
specifications or regulations as they affect the installation of the stove. Please note that it is a
legal requirement under England and Wales Building Regulations that the installation of the
stove is either carried out under Local Authority Building Control approval or is installed by
a Competent Person registered with a Government approved Competent Persons Scheme.
HETAS Ltd operate such a Scheme and a listing of their Registered Competent Persons can
be found on their website at www.hetas.co.uk.
It should be noted that the current Building Regulations requirements are given in Ap-
proved Document J. These requirements may also be met by adopting the relevant recom-
mendations given in British Standards BS 8303 and BS EN 15287-1.
WARNING: Health and Safety Advice Notice
The installation of this heating appliance is governed by the Health and Safety at Work Act
1974. It is the responsibility of the installer to ensure that all requirements of this Act are met
during the installation works. Attention is drawn in particular to the following:
Handling:
The appliance is a heavy item and adequate facilities must be available for loading,
unloading and site handling.
Fire Cement:
Some types of fire cement are caustic and should not be allowed to come into contact
with the skin. Protective gloves should be worn when handling fire cement. In case of
contact with the skin wash immediately with plenty of water.
Asbestos:
This stove contains no asbestos. If there is a possibility of disturbing any asbestos in
the course of installation then please seek specialist guidance and use appropriate
protective equipment.
Metal Parts:
When installing or servicing this stove care should be taken to avoid the possibility of
personal injury.
Important Warning –Preparatory Work and Safety Checks:
• This stove must not be installed into a chimney that serves any other heating appliance.
• There must not be an extractor fan fitted in the same room as the stove as this can cause
the stove to emit fumes into the room.
• If this appliance is installed into an existing chimney, the chimney must first be swept
and examined for soundness and suitability before the appliance is installed (see also
section headed "Chimney").
RAIS - manual for PALO, PALO C AND PILAR
7