Pressure Settings For Fl At Jet Nozzles - WAGNER GM 5000EA Operating Manual

EDITION 03/2012
OPERATING MANUAL
By turning the adjusting screw (A
adjusted on the material valve. By reducing of this cross-section under the same pressure
settings you might create a further refi nement of the atomisation, i.e. turning the
adjustment screw up.
5.3.2
PRESSURE SETTINGS FOR FLAT JET NOZZLES
There are 8 fl at jet nozzle sizes from 0.6 to 2.0 available. There are 3 air cap types. Each
air cap can be used in combination with 2 or 3 nozzles sizes. Only matching nozzle
components may be used. During the calibration of the material pressure (P
atomizing air pressure (P
central position. These presettings are based on a paint viscosity of 22 DIN 4 sec.
Pressure settings
Material pressure (P
MAT
Atomizing air pressure (P
Note:
In the table, default values are included. Depending on the material, conditions and the
desired result different values are possible or necessary.
By turning the adjusting screw (A
adjusted on the material valve. By reducing of this cross-section under the same pressure
settings you might create a further refi nement of the atomisation, i.e. turning the
adjustment screw up.
Note:
In this setting the spray pattern is reduced.
ORDER NUMBER DOC 2319149
) side of the gun, the outlet cross-section can be
MV
Spraying direction
Stop (A ) to front
MV
Smaller cross-section
) the air control lever shown in the fi gure B_03266 must be in
ZL
Air cap 0.4-0.8
) 0.5 bar to 1.0 bar
) 1.0 bar to 2.5 bar
ZL
) side of the gun, the outlet cross-section can be
MV
Rotate up
Rotate down
Air cap 1.0-1.4 Air cap 1.6-2.0
1.0 bar to 2.0 bar 1.0 bar to 3.0 bar
1.5 bar to 2.5 bar 1.5 bar to 3.0 bar
GM 5000EA
Stop (A ) to back
MV
Greater cross-section
B_03267
) and the
MAT
29