Replacing A Memory Module - Lenovo 7387 Hardware Maintenance Manual

4. There are three plastic tabs on each side of the bezel. While applying pressure on the top of the bezel,
release each tab starting with the tabs at the top.
Note: The power switch/LED assembly cable is connected inside the bezel. Be careful to not damage
the cable and connectors when removing the bezel from the chassis.
5. When the tabs are all released, remove the bezel from the chassis. To replace the bezel:
6. Route the power switch/LED cable through the hole in the chassis and to the system board.
7. Align the tabs in the chassis and snap it into position. Install the two screws on each side to secure
the bezel.
8. Reconnect the power switch/LED cable to the system board.

Replacing a memory module

1. Remove the left-side cover. See "Removing the covers" on page 70.
2. Locate the memory connectors. See "Identifying parts on the system board" on page 71.
3. Open the retaining clips and remove the failing memory module.
74
Hardware Maintenance Manual Lenovo 3000 J Series