Lenovo 7387 Hardware Maintenance Manual page 56

Diagnostic Error Code
005-010-XXX 005-011-XXX 005-012-XXX 005-013-XXX
Video Signal failure
005-016-XXX Video Simple Pattern test failure
005-024-XXX Video Addressing test failure
005-025-XXX Video Checksum Value error
005-027-XXX Video Configuration/Setup error
005-031-XXX Video Device Cable failure
005-032-XXX Video Device Controller failure
005-036-XXX Video Register error
005-038-XXX System BIOS extension failure
005-040-XXX Video IRQ failure
005-195-XXX Video Test aborted by user
005-196-XXX Video test halt, error threshold exceeded
005-197-XXX Video test warning
005-198-XXX Video test aborted
50
Hardware Maintenance Manual Lenovo 3000 J Series
FRU/Action
1. Video card, if installed
2. System board
1. Video Ram
2. Video card, if installed
3. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Run Setup
2. Video drivers update
3. Video card, if installed
4. System board
1. Video cable
2. Monitor
3. Video card, if installed
4. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out
is connected and/or enabled. See Chapter 6
"Diagnostics, Test and Recovery Information" on
page 41
2. Re-run test
3. Replace the component called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6
"Diagnostics, Test and Recovery Information" on
page 41
2. Flash the system and re-test. See "Flash update
procedures" on page 185
3. Go to "Undetermined problems" on page 67