Lenovo 7387 Hardware Maintenance Manual page 57

Diagnostic Error Code
005-199-XXX Video test failed, cause unknown
005-2XX-XXX 005-3XX-XXX Video subsystem error
006-000-XXX Diskette interface Test Passed
006-0XX-XXX Diskette interface error
006-195-XXX Diskette interface Test aborted by user
006-196-XXX Diskette interface test halt, error threshold
exceeded
006-197-XXX Diskette interface test warning
006-198-XXX Diskette interface test aborted
006-199-XXX Diskette interface test failed, cause
unknown
006-25X-XXX Diskette interface Error
011-000-XXX Serial port Interface Test Passed
011-001-XXX Serial port Presence
011-002-XXX 011-003-XXX Serial port Timeout/Parity
error
011-013-XXX 011-014-XXX Serial port Control
Signal/Loopback test failure
011-015-XXX Serial port External Loopback failure
FRU/Action
1. Go to "Undetermined problems" on page 67
2. Flash the system and re-test. See "Flash update
procedures" on page 185
3. Replace component under function test
1. Video card, if installed
2. System board
No action
1. Diskette drive Cable
2. Diskette drive
3. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. If a component is called out, make sure it is
connected and/or enabled
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test. See "Flash update
procedures" on page 185
3. Go to "Undetermined problems" on page 67
1. Go to "Undetermined problems" on page 67
2. Flash the system and re-test
3. Replace component under function test
1. Diskette drive cable
2. Diskette drive
3. System board
No action
1. Remove external serial device, if present
2. Run setup, enable port
3. System board
System board
System board
1. Wrap plug
2. System board
Chapter 7
.
Symptom-to-FRU Index
51