Replacing An Optical Drive - Lenovo 7387 Hardware Maintenance Manual

4. Slide the drive toward the rear of the chassis until it can be removed.
5. If the drive you are replacing has jumpers on the rear, make sure the jumpers on the new drive are in the
same exact position as the drive being replaced.
6. Slide the new drive into the bay until the screws holes on each side are aligned and install two screws in
each side of the drive.
7. Reconnect the signal and power cables to the rear of the hard disk drive.
8. Go to "Completing the FRU replacement" on page 92.

Replacing an optical drive

1. Remove the left-side and right-side covers. See "Removing the covers" on page 70.
2. Disconnect the power cable and signal cable from the optical drive.
3. Remove the two screws that secure the drive on each side.
.
Chapter 8 Replacing FRUs (Types 7387, 7388, 7389, 7393, 7394, and 7395)
89