Epson DLQ-3000+ Service Manual page 30

Overlapping multi-part forms
P L
Figure 1-11. Printing Area for Overlapping Multi-part Forms
Table 1-18. Printing Area for Overlapping Multi-part Forms
Paper width
Paper length
Left margin
Right margin
Top margin
Bottom margin
Left margin from the multi-part form to
the base sheet
Right margin from the multi-part form
to the base sheet
Notes:
1. Do not feed paper backward.
2. Use only the specified paper path for continuous paper.
3. The paper feeding pitch in the top 75 mm (2.9") may be irregular.
4. Forms-override printing is available for 2 lines after the paper end is detected. The end of
the printable area is 4.2 mm or more apart from the bottom edge of the paper.
Rev. A
L M B
L M
P r i n t a b l e A r e a
(PW)
(PL)
(LM)
(RM)
(TM)
(BM)
(LMB)
(RMB)
P W
: P r i n t a b l e A r e a
Continuous paper
Refer to Section 1.3.4.
Refer to Section 1.3.4.
19 mm (0.748") or more
19 mm (0.748") or more
21.2 mm (0.835") or more
4.2 mm (0.165") or more
13 mm (0.512") ± 3 mm (0.118")
13 mm (0.512") ± 3 mm (0.118")
Product Description
T M
R M B
R M
P e r f o r a t i o n
B M
T M
1-21