Controller Position - Pride Mobility QUANTUM JAZZY 1420 Owner's Manual

V . C O M F O R T A D J U S T M E N T S
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a
hex key. See figure 19.
To adjust the foot platform angle:
1. Turn the setscrew clockwise to raise the front of
the foot platform.
2. Turn the setscrew anticlockwise to lower the front
of the foot platform.

Controller Position

You can move the controller in toward or out away
from the armrest, or change the position of the
controller for either left-hand or right-hand use.
WARNING! Do not place the controller
harness so that it can be pinched in
the seat frame or the power base
frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the
floor.
2. Loosen the setscrew on the controller bracket. See
figure 12.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
NOTE: If your power chair is equipped with a Spe-
cialty Seat, Synergy Seat or TRU-Balance Power
Positioning System, loosen the setscrews in the
mounting block, slide the controller in or out to the
desired position, then tighten the setscrews. See fig-
ure 20.
To change the controller position:
1. Turn off the power to the controller.
2. Disconnect the controller from the power base.
3. Cut the wire tie(s) securing the controller harness to the armrest.
4. Flip up the armrest so it is perpendicular to the floor.
5. Loosen the setscrew on the controller bracket. See figure 12.
6. Slide the controller out of the armrest.
7. Loosen the setscrew in the other armrest.
8. Place the controller in the other armrest.
9. Tighten the setscrew to secure the controller.
10. Use a wire tie to secure the controller harness to the armrest. See figure 13.
11. Plug the controller into the power base.
NOTE: If your power chair is equipped with a Specialty Seat, Synergy Seat or TRU-Balance Power Positioning
System, loosen the mounting screws in the mounting block, transfer the mounting block and controller to the
opposite armrest, and tighten the mounting screws. See figure 20.
26
Figure 19. Foot Platform Angle
SETSCREWS
Figure 20. Adjusting Controller Position (Mounting
Block Shown)
www.pridemobility.com
SETSCREW
MOUNTING BLOCK
MOUNTING SCREWS
Quantum Jazzy 1420